LD32/SP32 Industrial Docking Connector Specifications

LD32/SP32 Square Flange Connector Dimensions and Materials

LD32/SP32 Industrial Docking Connector: Dimensions, Materials, and Specifications

This page provides the verified dimensional data, technical specifications, and material construction for the LD32/SP32 Industrial Docking Connector. It is intended for design engineers, procurement specialists, and maintenance teams who need to confirm mechanical fit, electrical ratings, and environmental suitability before integrating this square flange docking connector into semiconductor equipment, automation systems, or industrial control cabinets.

Use the details below to check panel cutout requirements, mating interface constraints, and material compatibility for your application. If a specific parameter for your project is not listed, contact our engineering team with your required current, voltage, IP rating, and cable entry size for a verified recommendation.

Dimensional Overview and Panel Mounting

The LD32/SP32 series uses a square flange mounting format designed for secure panel installation in industrial enclosures. The illustration referenced on this page specifies the critical envelope dimensions, including flange width, panel cutout, and overall connector depth. Verify these dimensions against your enclosure layout before machining the panel opening.

For detailed dimensional drawings and material callouts, refer to the LD32/SP32 square flange connector dimensions and materials catalog.

Technical Specifications and Electrical Limits

The LD32/SP32 docking connector is engineered for high-density signal and power transmission in demanding industrial environments. Key electrical parameters—including rated current, rated voltage, insulation resistance, and contact resistance—are defined by the series design and should be reviewed against your load profile.

Note that rated values represent the connector's nominal capability under standard test conditions. Actual performance may require derating based on ambient temperature, continuous load, and wiring method. Confirm your operating envelope with the specification table before finalizing the design.

Material Construction and Environmental Protection

Material selection for the LD32/SP32 series focuses on durability, corrosion resistance, and reliable mating cycles. The housing, contact plating, and sealing elements are specified to support industrial service conditions. Verify the IP protection rating and temperature range against your installation environment, particularly for washdown areas, outdoor cabinets, or cleanroom applications.

For semiconductor equipment applications where cleanliness and mating reliability are critical, review the LD32/SP32 square flange connector case study for semiconductor equipment.

Selection Checklist for Your Application

Before ordering, confirm the following points against the specification sheet:

• Pin count and contact layout match your required signal and power channels.
• Panel cutout and mounting hole pattern align with your enclosure design.
• Rated current and voltage meet or exceed your load requirements with appropriate derating.
• IP rating and operating temperature suit the installation environment.
• Cable entry size and termination method are compatible with your wire gauge and assembly process.
• Mating interface and locking mechanism match the counter-part connector in your system.

Next Step: Request a Verified Specification

If the LD32/SP32 docking connector meets your dimensional and electrical requirements, submit an inquiry with your application details—including pin count, current per contact, IP rating, and panel thickness. Our team will confirm the exact part configuration and provide the verified specification sheet for your project.